Filter
Top Products
e-STUDIO3511/4511 TRANSFER/TRANSPORT UNIT 14 - 8 November 2003 © TOSHIBA TEC
14
(3) Remove 1 screw and 2 stand plates.
Fig. 14-710
Stand plate (long)
Stand plate
(short)
Fig. 14-709
[B] Transfer belt
Note: Wearing gloves is recommended to avoid
direct touch by bare hands to the transfer
belt surface.
(1) Take off the transfer belt unit ( Chapter 14.7
[A]).
(2) Remove 2 clips and take off the shaft by sliding
it to the rear side.
Note: When installing the shaft, insert the narrow
part of the shaft into the stay on the rear side
and fit it into the front side by sliding it.
4.If the transfer belt drive gear is not
properly engaged, the hole positions of
the fixing screw (as shown in the figure
at right) may not match. In this case,
operate the main motor for approx. 1
second in the Test Mode (03-101) to
engage the drive gear securely and then
install the unit.
Fig. 14-708
04/05