Filter
Top Products
November 2003 © TOSHIBA TEC 16 - 9 e-STUDIO3511/4511 FUSER UNIT/PAPER EXIT SECTION
16
(4) Temperature control at energy saving mode
This equipment has the following two types of temperature control for saving energy and returns to
ready status to perform printing in each mode upon printing request.
The period of time from the printing request to this mode can be set in the Setting Mode (08) or by an
from administrator.
Administrator setting procedure:
[USER FUNCTIONS] button → [ADMIN] (input of administrator’s password) → [GENERAL] →
[ENERGY SAVER]
Auto Power Save Mode (Setting Mode (08-205)):
When the printing is not performed in a specified period of time (default setting: 15 min.) after the
previous printing is completed, the equipment enters to Auto Power Save Mode. ON/OFF of IH coil
is controlled to maintain the fuser belt surface temperature at 100
o
C.
Auto Shut Off Mode (Setting Mode (08-206)):
When the printing is not performed in a specified period of time (default setting: e-STUDIO3511: 60
min. / e-STUDIO4511: 90 min.) after the equipment entered to Auto Power Save Mode, the equip-
ment then enters to Auto Shut Off Mode to turn OFF the IH coil.
OFF
Warming-up Ready During printing Fixed time (08-205)
Fixed time (08-206)
Auto Power Save
Mode
Auto
Shut Off
Mode
100
C
180
0
Temperature
of fuser belt
IH coil ON
Fig. 16-405