Filter
Top Products
e-STUDIO3511/4511 TRANSFER/TRANSPORT UNIT 14 - 14 November 2003 © TOSHIBA TEC
14
Fig. 14-732
[H] Transfer belt cleaner auger motor /
Transfer belt cleaner clutch
(1) Take off the transfer belt cleaning unit
( Chapter 14.7 [F]).
(2) Separate the transfer belt cleaning unit into
2 parts.
( Chapter 14.7 [G]).
(3) Release the latch and take off the gear.
Gear
Fig. 14-729
(8) Remove 3 conductive tapes.
Fig. 14-730
Note: When assembling, use the new conductive
tape. Also, attach the conductive tape to the
transfer belt cleaning blade referring to the
figure on the right.
Fig. 14-731
Cleaning blade
(9) Remove 2 screws and take off the transfer belt
cleaning blade.
Notes:1. Make sure not to touch or damage the
edge of the blade.
2. Check the color deviation after replacing
the transfer belt cleaning blade.
04/10
Conductive tape
47 mm 160 mm
41 mm