Filter
Top Products
16
November 2003 © TOSHIBA TEC 16 - 17 e-STUDIO3511/4511 FUSER UNIT/PAPER EXIT SECTION
Fig. 16-705
Fig. 16-706
Fig. 16-708
(6) Remove 1 bushing from each side of the oil
roller.
Spring (B)
(4) Remove spring (B) on each end of the oil roller.
(5) Take off the oil roller.
- Front side -
- Rear side -
Note: Install the oil roller according to the marking
on the frame (the shaft end with a groove
should point at the rear side).
Fig. 16-707
[C] Cleaning roller
(1) Take off the oil roller from the cleaning unit (
Chapter 16.7 [B]).
(2) Remove 1 E-ring and 1 bushing from the
cleaning roller front side. Then take off the
cleaning roller.
(3) Remove the spring (A) on each end of the
frame.
Note: When installing, make sure that the oil roller
rotates smoothly by turning the gear (C) of
the cleaning roller manually for a several
times.
Oil roller
Cleaning roller
Spring (A)
Groove
Gear (C)
Bushing
E-ring
Bushing