Filter
Top Products
16
November 2003 © TOSHIBA TEC 16 - 19 e-STUDIO3511/4511 FUSER UNIT/PAPER EXIT SECTION
Fig. 16-715
Fig. 16-716
Bracket
Fig. 16-714
Bearing
(5) Remove 1 bearing.
(6) Insert a flat-head screwdriver into the slit of the
fuser belt guide on the rear side. Then slide
the plate while opening the slit by the flat-head
screwdriver. Take off the fuser belt guide from
the fuser roller.
Note: Be careful not to scratch the fuser belt.
Fuser belt guide
Fuser belt
(7) Remove 2 screws and take off the bracket.
(1) Remove the cleaning unit ( Chapter 16.7 [B]).
(2) Remove the IH coil ( Chapter 16.7 [D]).
(3) Push down the pressure releasing levers on
both sides.
(4) Remove 1 C-ring and 2 gears.
Fig. 16-713
C-ring
Gear
Pressure releasing
lever