Filter
Top Products
November 2003 © TOSHIBA TEC 12 - 19 e-STUDIO3511/4511 DEVELOPER UNIT
12
(7) Front side: Remove the following parts installed
on the shaft of the developer sleeve in order:
Bushing, collar, roller, bearing-1, E-ring,
bearing-2 and oil seal.
* Procedure for replacing an oil seal:
Page 12-23
(8) Rear side: Remove the following parts installed
on the shaft of the developer sleeve in order:
E-ring, bushing, collar, roller, bearing-1, E-ring,
gear, pin, bearing-2 and oil seal.
(9) Take off the developer sleeve.
* Procedure for replacing an oil seal:
Page 12-23
(A-6) Mixer
(1) Discharge the developer material ( Chapter
12.8 (A-2)).
(2) Take off the developer sleeve ( Chapter 12.8
(A-5)).
(3) Front side: Remove the following parts
installed on the shaft of each mixer in order:
E-ring, bushing-1 and bushing-2.
* Procedure for replacing an oil seal:
Page 12-23
(4) Rear side: Remove the following parts installed
on the shaft of each mixer in order: E-ring, gear,
bearing and oil seal.
* Procedure for replacing an oil seal:
Page 12-23
Fig. 12-813
Fig. 12-814
Fig. 12-815
Fig. 12-816
Developer sleeve
Bushing-2
E-ring
Bushing-1
E-ring
E-ring
Gear