Filter
Top Products
November 2003 © TOSHIBA TEC 5 - 5 e-STUDIO3511/4511 CONTROL PANEL
5
Displayed when paper size needs to be
specified for bypass feeding such as duplex
copying
Displayed when no paper is in the selected
feeder at Cover Copying Mode
Displayed when the direction of cover page
is different from that of other pages at Cover
Copying Mode
Displayed when the paper size of cover page
is different from that of other pages at Cover
Copying Mode
Displayed when no insertion sheet is in the
selected drawer at Sheet Insertion Mode
Displayed when the size of insertion sheet
(sheet 1) is different from that of other pages
at Sheet Insertion Mode
Displayed when the size of insertion sheet
(sheet 2) is different from that of other pages
at Sheet Insertion Mode
Displayed when the direction of insertion
sheet (sheet 1) is different from that of other
pages at Sheet Insertion Mode
Displayed when the direction of insertion
sheet (sheet 2) is different from that of other
pages at Sheet Insertion Mode
Displayed when the selected paper size is
other than A4/LT at OHP mode
Papers in LCF are set incorrectly
Displayed when the selected paper size is
not specified for hole punching
Displayed when the paper sizes are mixed at
Staple Sorting Mode
Displayed when the paper size is not
specified for stapling at Staple Sorting Mode
Finisher is full of papers
Trouble in the stapler unit in finisher
No stapler in finisher section
No stapler in saddle stitch unit
Select a paper size
for bypass feeding
Place the blank
sheets in bypass tray
and select the paper
size
Place the blank
sheets in the same
direction as the
originals
Place the same size
blank sheets as the
originals
Place insertion
sheets in the bypass
tray and select the
paper size
Select the same size
insert1 sheets as the
originals
Select the same size
insert2 sheets as the
originals
Set insert1 sheets in
the same direction as
the originals
Set insert2 sheets in
the same direction as
the originals
Set transparency film
in A4/LT direction
CHECK PAPER IN
LARGE CAPACITY
FEEDER
CANNOT PUNCH
THIS SIZE PAPER
Remove paper from
the finisher
Cannot staple this
size
Remove paper from
the saddle stitch unit
Examine stapler
Check staple
cartridge
Check staple cartridge
in the saddle stitch unit
No. Message State of equipment Note
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57