Filter
Top Products
e-STUDIO3511/4511 DEVELOPER UNIT 12 - 18 November 2003 © TOSHIBA TEC
12
(3) Remove 2 screws and take off the doctor blade.
(A-5) Developer sleeve
(1) Discharge the developer material ( Chapter
12.8 (A-2)).
(2) Take off the right cover ( Chapter 12.8 (A-4)).
(3) Remove 3 screws. Disconnect 1 connector and
take off the front cover.
(4) Remove 1 screw and take off the polarity
adjustment plate.
Note: Before disassembling, record (mark if any)
the scale pointed by the polarity adjustment
lever. Then match the polarity adjustment
plate at the scale previously recorded when
reassembling.
(5) Remove 1 screw and take off the bracket.
(6) Remove 3 screws and take off the rear cover.
Doctor blade
Polarity adjustment plate
Fig. 12-809
Fig. 12-810
Fig. 12-811
Fig. 12-812
Front cover
Bracket
Rear cover