Filter
Top Products
e-STUDIO3511/4511 DEVELOPER UNIT 12 - 22 November 2003 © TOSHIBA TEC
12
(6) Remove the following parts installed on the
shaft of the developer sleeve in order: E-ring,
bearing, gear, bearing and oil seal.
(7) Take off the developer sleeve.
* Procedure for replacing an oil seal:
Page 12-23
Fig. 12-827
Developer sleeve
(B-4) Mixer
(1) Discharge the developer material ( Chapter
12.8 (B-1)).
(2) Take off the developer sleeve ( Chapter 12.8
(B-3)).
(3) Front side: Remove the following parts in order:
E-ring, bushing-1 and bushing-2.
* Procedure for replacing an oil seal:
Page 12-23
Fig. 12-828
Bushing-2
E-ring
Bushing-1
E-ring
(4) Remove the following parts installed on the
shaft of the developer sleeve in order: C-ring,
bearing-1, C-ring, E-ring, bearing-2 and oil seal.
* Procedure for replacing an oil seal:
Page 12-23
(5) Rear side: Remove 1 screw and take off the
gear assembly.
Gear assembly
Fig. 12-825
Fig. 12-826