Filter
Top Products
e-STUDIO3511/4511 DRUM RELATED SECTION 11 - 18 November 2003 © TOSHIBA TEC
11
[H] Temperature/Humidity sensor
(1) Take off the front cover, receiving tray and
left cover ( Chapter 2.5.1 [A] [B] [F]).
(2) Remove 2 screws and take off the inner cover.
Fig. 11-735
Fig. 11-736
[I] Ozone filter
(1) Remove 1 screw and take off the cover.
(2) Pull out the ozone filter.
(3) Disconnect 1 connector. Then release 2
latches and take off the temperature/humidity
sensor.
Fig. 11-734
Inner cover
Ozone filter
Latch
Fig. 11-737
[J] Ozone exhaust fan
(1) Take off the SYS board with the whole case
( Chapter 2.5.2 [C]).
(2) Take off the ozone filter ( Chapter 11.7 [I]).
(3) Disconnect 1 connector and remove 2 screws.
Take off the ozone exhaust fan with the whole
cover.
Connector
Temperature/
Humidity sensor