Filter
Top Products
Encore Presentation System • User’s Guide • Rev 04 105
3. Hardware Installation
Program and Source Link Connections
Connect:
~ Processor 1 Program Link Out > Processor 2 Program Link In
~ Processor 2 Program Link Out > Processor 3 Program Link In
~ Processor 3 Program Link Out > Processor 1 Program Link In
3. Program Link Connections (DVI-I), Four Projectors
Use the following diagram for reference:
Figure 3-19. Program Link Connections, Four Projectors
Connect:
~ Processor 1 Program Link Out > Processor 3 Program Link In
~ Processor 2 Program Link Out > Processor 1 Program Link In
~ Processor 3 Program Link Out > Processor 4 Program Link In
~ Processor 4 Program Link Out > Processor 2 Program Link In
4. Source Link Connections (DVI-I), All Configurations
For Processor 1, connect each M/E’s Source Link Out connector to the
associated
Source Link In connector on processor 2, as illustrated below.
Figure 3-20. Source Link Connections
5. Repeat the procedure for all remaining processors in your configuration.
6. For the last processor in the chain, do not connect the Source Link Out
connectors.
Once you have reviewed all of the sections in this chapter, please continue with Chapter 4,
“
Controller Orientation” on page 107.
Processor 1
(VP only)
Program
Link Out
Program
Link In
Processor 2
(VP or VPx)
Program
Link Out
Program
Link In
Processor 3
(VP or VPx)
Program
Link Out
Program
Link In
Processor 4
(VP or VPx)
Program
Link Out
Program
Link In
Processor 1
(VP only)
Source Link
1 Out
Source Link
1 In
Processor 2
(VP or VPx)
Source Link
1 Out
Source Link
1 In
Processor [n]
(VP or VPx)
Source Link
1 Out
Source Link
1 In
Source Link
2 Out
Source Link
2 In
Source Link
2 Out
Source Link
2 In
Source Link
2 Out
Source Link
2 In
Source Link
3 Out
Source Link
3 In
Source Link
3 Out
Source Link
3 In
Source Link
3 Out
Source Link
3 In
Important
An M/E’s Source Link Out must always be connected to its
associated M/E
Source Link In on the next chassis, and
never cross-routed.