Barco 26-0313000-00 Projector User Manual


 
Encore Presentation System • User’s Guide • Rev 04 263
6. System Setup
ID Setup and Remote Enable
b. Ensure that the ImagePRO is running software version 2.30 or greater.
To verify, press
SETUP > TECH SUPPORT to display the Tech
Support Menu
. The version is listed on line 2.
•Press
ESC repeatedly to return to the top level.
c. Set the ImagePRO’s output resolution.
Press
SETUP > OUTPUT to display the Output Menu.
On the output resolution line, press
SEL to select the desired
resolution, then press
SEL to accept.
Scroll to the
SAVE CONFIG line and press SEL to save the
output configuration.
•Press
ESC repeatedly to return to the top level.
d. Press SETUP > SYSTEM > ETHERNET to display the Ethernet Menu.
e. On the MODE line, enable the function. Once enabled, a message
appears that the unit is searching for a DHCP server.
f. Scroll to the DHCP line, and verify that DHCP is enabled. If not, enable
this function.
g. On the IP line, confirm that an IP address has been received from the
Encore Controller.
h. Scroll to the REMOTE CONTROL line and press SEL to display the
Barco Remote Control Menu.
i. Scroll to the ID line and set a unique ID for the unit.
j. Scroll to the CONNECT line and enable this function. Once enabled, a
message appears that the unit is attempting to connect, followed by a
message that a connection has been established.
k. Scroll to the SAVE CONFIG line and press SEL to save the remote
control configuration.
l. Press ESC repeatedly to return to the top level.
m. Repeat step 5 for all other ImagePRO units in your system.
Note
When remote control is on, the unit’s input switching buttons
are disabled, but you can still navigate through the menus.
All switching control now originates from Encore’s console.