Barco 26-0313000-00 Projector User Manual


 
Encore Presentation System • User’s Guide • Rev 04 261
6. System Setup
System Setup Sequence
póëíÉã=pÉíìé=pÉèìÉåÅÉ
This section provides a top level view of the entire Encore setup procedure, plus links to
each individual sequence.
Preliminary steps:
1. ID Setup and Remote Enable,” page 262.
2. Peripheral Power Up and Status Check,” page 264.
3. Return to Factory Default,” page 266.
Next, set up all menus under the MISC heading:
4. Touch Screen Calibration,” page 267.
5. Programming EDID,” page 268.
6. Restore from Flash Memory Card,” page 269.
Next, set up all menus under the System heading:
7. Router Setup,” page 270. Router setup
8. D/A Setup,” page 274. D/A setup
9. Input Patching,” page 275. Input Patching
10. Destination Setup,” page 277. Destination Setup
11. AUX Destination Setup,” page 281. Aux Destination Setup
Next, set up all menus under the Output heading:
12. Output Format Setup,” page 285.
13. Sync Setup,” page 286.
14. Genlock Setup,” page 287.
15. Projector Setup,” page 288.
Set up all background inputs, all primary sources and the DSK:
16. Background Setup,” page 291.
17. Input Setup,” page 293.
18. DSK Setup,” page 296.
To complete your setup:
19. Saving the Setup,” page 299.
20. Back up System,” page 300.
All of the above procedures are covered in the following sections.
Important
For the optimum Encore setup, it is recommended that you
follow all procedures in the order outlined below.