Barco 26-0313000-00 Projector User Manual


 
Encore Presentation System • User’s Guide • Rev 04 305
7. Operations
Operational Configuration
qçìÅÜ=pÅêÉÉå=`~äáÄê~íáçå
As an excellent prerequisite to all operating procedures, it is recommended that you
calibrate the Touch Screen.
Use the following steps to calibrate your Touch Screen display:
1. In the System Keypad, press MISC to display the Miscellaneous Menu.
2. Press {LCD SETTINGS} to display the LCD Settings Menu.
3. Press {LCD CAL} to display the Touch Screen Calibration Menu.
4. (Controller LC only) On the top LCD line, select the touchscreen to calibrate.
5. Follow the directions on the menu to complete the calibration procedure.
6. (Controller LC only) Repeat steps 1 through 5 for the other LCD touchscreen.
7. For both Controllers, use the controls on the LCD Settings Menu to adjust
brightness and contrast as desired.
When the procedure is complete, the Controller remembers this calibration setting until it is
performed again.
táÇÉ=pÅêÉÉå=j~êâÉêë
If you are using a wide screen configuration, ensure that your Wide Screen Markers are
enabled. In Chapter 6, refer to the “
Wide Screen Projector Setup" section on page 289
for details.
In wide screen applications, Wide Screen Markers are thin vertical
green lines at the
edges of the screens that are used to denote the
actual projected image area.
Using edge feathering and data doubling, Encore provides perfect and seamless wide
screen images. Because of the required overlap, a
portion of the original image is unused,
and does not get projected. The location of the unused portion depends on your selected
justification — left or center.
With each type of justification, the Wide Screen Markers
accurately denote the unused
portion, thus enabling you to properly compose your screens.
Left Justified Markers
The figure below illustrates the Wide Screen Marker in a left justified
configuration. Images to the left of the green vertical line are projected. Images to
the right are not.
Figure 7-4. Wide Screen Marker, Left Justification
Note
Markers apply to horizontal blends (e.g., 3W x 1H), and to
horizontal + vertical arrays (e.g.,
2W x 2H), but do not apply to
vertical blends (e.g.,
1W x 3H).
Preview #2Preview #1
Preview #1 Preview #2
Wide
Screen
Marker