Filter
Top Products
264 Encore Presentation System • User’s Guide • Rev 04
6. System Setup
Peripheral Power Up and Status Check
mÉêáéÜÉê~ä=mçïÉê=ré=~åÇ=pí~íìë=`ÜÉÅâ
Encore system setup: Step 2.
Use the following steps to power up your routers and check system status:
1. Power up all routers in your system, and allows them to fully boot up. These are
your devices with static IP addresses.
2. Power up all additional peripherals, such as monitors and projectors.
3. Check the Encore System Status Menu, and ensure that all devices have been
recognized. By default, this menu should appear at power up. If it is not shown,
press
STATUS in the System Keypad.
4. Check code compatibility — when the Encore Controller connects to the Video
Processor(s), ScreenPRO-II units and PresentationPRO-II units, it automatically
checks the compatibility of the code versions.
~ If the Controller’s code version matches that of the Video Processor(s),
ScreenPRO-II units and PresentationPRO-II units, the
System Status
Menu
is shown — and you do not need to download code.
~ If the message “Checksum Mismatch” appears on the System Status
Menu
, it is highly recommended that you download code. However, if
the Controller buttons are
not flashing, then the code is compatible and
therefore usable. Please continue with the “
Downloading Code”
procedure on page 265.
~ If the Controller’s code version is incompatible with the code version of a
Video Processor, a ScreenPRO-II or a PresentationPRO-II (or a
combination of units), all buttons will flash on the Controller console. The
System Status Menu is shown with the message “Please Upgrade.”
Please continue with the “
Downloading Code” procedure on page 265.
2
Note
If Barco MatrixPRO series routers are connected and
powered on first, before the Controller, they will be
automatically "discovered" by the Controller.