Filter
Top Products
312 Encore Presentation System • User’s Guide • Rev 04
7. Operations
Working with Groups
tçêâáåÖ=ïáíÜ=dêçìéë
A Group is a single button that represents a certain number of destinations, as
programmed by the user. For example, the
Group 1 button can represent destination 1 or
destinations
1, 2 and 3.
• On the Controller SC, 4 group buttons are available.
• On the Controller LC, 8 group buttons are available.
Groups are activated by pressing (lighting) the desired
Group button. With groups
activated, your setups and “looks” will be routed to the selected destinations only. Any
combination of
Group buttons can be enabled, but all group selections (whether individual
or multiple) are mutually exclusive.
The following topics are discussed in this section:
• Learning a Group
• Adding or Removing Destinations from a Group
• Activating a Group
• Clearing a Group
• Unlearning a Group
• Group Notes
iÉ~êåáåÖ=~=dêçìé
Use the following steps to learn (program) a group button:
1. Controller LC:
a. On the Destination Bus, activate the desired destination(s).
b. Press and hold Learn.
c. Press the desired Group button.
2. Controller SC:
a. Press and hold the desired Group button.
b. On the Destination Bus, press the desired destination button(s).
c. Release the Group button.
Group
1
Note
By default, only Group 1 is assigned to Destination 1. All
other groups must be defined by the user.
Note
This method can also be used to add (or remove)
destinations to/from the group — simply by re-learning the
button with a new array of destinations.
Note
This method also works on the Controller LC.