Barco 26-0313000-00 Projector User Manual


 
284 Encore Presentation System • User’s Guide • Rev 04
6. System Setup
AUX Destination Setup
11. In the SDI section:
a. On the SDI Router Name line, select the router from which SDI sources
will be routed to the ImagePRO (or PrePRO-II).
b. On the SDI Router Output line, select the specific router output that you
designated as an
Aux output.
c. On the ImagePRO Input (or PrePRO-II Input) line, select the
ImagePRO or PrePRO-II input to which the SDI router output is
connected.
12. In the DVI section (applies to ImagePRO Aux destinations only):
a. On the DVI Router Name line, select the router from which DVI sources
will be routed to the ImagePRO.
b. On the DVI Router Output line, select the specific router output that you
designated as an
Aux output.
c. On the ImagePRO Input line, select the ImagePRO input to which the
DVI router output is connected.
13. Press {BACK} to return to the Destination Setup Menu.
14. Repeat from step 5 to configure another ImagePRO or PrePRO-II Aux
destination.
15. Press {BACK} to return to the System Menu.
16. In the System Keypad, press SAVE to save the new system configuration.
This completes the procedure for defining
ImagePRO or PrePRO-II Aux destinations. The
selected button(s) on the
Destination Bus are now active.
^ìñ=aÉëíáå~íáçå=pÉíìé=kçíÉë
Please note the following important points regarding Aux Destination Setup:
ImagePRO and PrePRO-II output setups must be performed locally on the units
themselves.
Only one router of each type (Analog, DVI and SDI) can be connected to an
ImagePRO unit.
In order to ensure that the ImagePRO and PresentationPRO-II units properly
process each input, an
Input Configuration File must be created for each input.
This function is accomplished with the Controller’s automatic “
Copy Down
feature, which is initiated by setting up your Processor and ScreenPRO-II inputs.
As you progress through the entire setup sequence, ensure that you complete the
Input Setup” procedure on page 293 to guarantee a “Copy Down.”
Note
In general, a “Copy Down” takes place automatically to all
destinations that are currently defined to be connected to a
given router.