Filter
Top Products
388 Encore Presentation System • User’s Guide • Rev 04
`K==réÖê~ÇáåÖ=pçÑíï~êÉ
Serial Upgrade Method
6. When the File Download Dialog appears, click Save to save the file to your
computer.
7. When the Save As Dialog appears, navigate to the target folder and click Save.
8. With the download complete, navigate to the target folder and double-click the
EXE to launch the installation shield.
9. Follow the prompts to install the upgrade package. At the conclusion of the
procedure, a new path will be created under
Start > Programs > Barco Folsom.
10. As required, please continue with the “Serial Upgrade Method” section on
page 388, or the “
Ethernet Upgrade Method” section on page 390.
pÉêá~ä=réÖê~ÇÉ=jÉíÜçÇ
Use the following steps to upgrade Encore software using a serial PC connection:
1. Connect the Console port on the back of the Encore Controller to the COM 1 port
on your PC.
2. Power-up the Encore Presentation System.
3. On the PC, click Start > Programs > Barco Folsom > Encore System_SPII
Controller Software #.##
.
4. In the next pop-up menu in sequence, click the Flash Loader line to launch the
Flash Loader utility.
Figure C-1. Flash Loader Utility
5. Click Communication > RS232 Config > Baud, and select 115200.
6. Click Communication > RS232 Config > COM Port, and select the COM port on
your PC to which the Controller is connected. If no other programs are using the
port, the “
Established communications” message appears at the bottom of the
Flash Loader.
Note
If you have not used the COM 1 port on your PC, an error
message will be shown at the bottom of the Flash Loader.