Filter
Top Products
282 Encore Presentation System • User’s Guide • Rev 04
6. System Setup
AUX Destination Setup
^ìñ=aÉëíáå~íáçå=pÉíìé
This section provides instructions for setting up an Aux destination.
Use the following steps to set up an Aux destination:
1. Ensure that you have properly configured one (or more) router outputs as “Aux”
outputs. If not, refer to the “
Router Setup” section on page 270 for instructions.
Step
19 deals specifically with Aux output setup.
2. In the System Keypad, press SYSTEM to access the System Menu.
3. Press {DEST SETUP} to display the Destination Setup Menu.
4. On the Destination line, select the Aux destination that you want to define.
5. Scroll to the Type line and select Aux.
6. Press {AUX SETUP} to display the Aux Setup Menu.
7. On the Source Mapping line, two choices are available:
~ Select Input Patch if you want to map Aux sources according to how
inputs are patched to buttons on the
Source Selection Bus. Note that
this is the typical choice.
~ Select Direct Map if you want the Source Selection bus to be a 1:1
mapping of your router inputs — for
this Aux destination only.
8. On the Router Name line, select the router on which you configured the Aux
output(s).
9. On the Router Output line, select the specific router output that you wish to
designate as the Aux destination. Note that only outputs configured as “
Aux” will
appear in the list.
10. Press {BACK} to return to the Destination Setup Menu.
11. Repeat from step 4 to configure additional Aux outputs.
12. Press {BACK} to return to the System Menu.
13. In the System Keypad, press SAVE to save the system configuration in memory.
This completes the procedure for defining Aux destinations. The selected button(s) on the
Destination Bus
are now active.
Note
On the Controller SC, up to 6 destinations can be assigned.
On the Controller LC, up to 32 destinations can be assigned.