Filter
Top Products
130 Encore Presentation System • User’s Guide • Rev 04
4. Controller Orientation
Controller Sections
• To clear a layer from Preview (so that it will transition off Program), press the
desired layer button, then press
Clear Layer. This action turns the button off, and
if the
Red LED above the button is lit, the layer transitions off Program.
Split — this important button determines how the mixer’s two layers work.
• Mix Mode — the Split button is off. In this mode, the two layers are ganged
together, offering a variety of additional transitions including the
Toggle, Mix
Source
and Swap functions.
~ Refer to the “Transition Functions Section” heading on page 142 for
details on the
Toggle, Mix Source and Swap buttons.
~ In Chapter 7, refer to the “Working with Layers” section on page 319 for
additional Mix Mode information.
• Split Mode — the Split button is on. In this mode, each layer works
independently. You have the freedom to size, position, manipulate and transition
each layer independently of the other. In Chapter 7, refer to the “
Working with
Layers” section on page 319 for additional Split Mode information.
• Join Mode — the Split button is on. The layer button that is currently blinking is
considered the “master.”
Press and hold the Split button, then press the other
(non-blinking) layer button to “join” the two layers together. Both layer buttons
blink, and in this mode, both are now joined.
~ Any manipulation that you perform to the “master” layer is also
performed to the joined layer. Both can be sized, positioned, moved and
manipulated as if they are one.
~ To separate the two layers, press and hold the Split button, then press
either
Layer button.
In Chapter 7, refer to the “
Using Join Mode” section on page 335 for additional
information.
• Blinking — if the Split button is blinking (after a Preset recall), the mixer will
change modes after the next transition.
DSK — press to select the unscaled DSK on Preview for transition to or from Program.
The button lights when selected. Please note:
• Using the DSK Input Setup Menu, you can select a DVI input, an analog input or
a captured frame as the DSK source.
• When the Red LED above the button is lit, the DSK is on Program.
• To clear the DSK from Preview (so that it will transition off Program), select the
DSK then press
Clear Layer. This action causes the button to turn off. If the red
led above the DSK button is lit, it will transition off of Program.
In Chapter 7, refer to the “
Modifying Keys” section on page 326 for additional DSK
information.
Split
DSK