Barco 26-0313000-00 Projector User Manual


 
340 Encore Presentation System • User’s Guide • Rev 04
7. Operations
Working with Live Modes
tçêâáåÖ=ïáíÜ=iáîÉ=jçÇÉë
The following topics are discussed in this section:
Using Live Switch Program/Preview Mode
Using Live Switch Source Mode
Live Mode Source Timing
rëáåÖ=iáîÉ=pïáíÅÜ=mêçÖê~ãLmêÉîáÉï=jçÇÉ
The Live Switch Program/Preview Mode turns both rows of the Source Selection Bus
into two buses, both of which can be used to route sources into PIPs and Keys:
The top row is the Program bus. When you select sources here, you perform live
"cuts" directly on Program.
The bottom is the Preview bus. When you select sources here, you can "cut" or
"transition" them to Program.
Use the following steps to utilize the Live Switch Program/Preview Mode:
1. On the Destination Bus, enable the desired destination(s).
2. On Preview, select the one layer that you want to remain enabled when you enter
the live mode. All other
Preview layers will be cleared.
3. Press Shift + Program/Preview. The Program/Preview button lights to indicate
that the mode is enabled.
~ When you first enter the mode, all layers on Preview (except the
selected one) are cleared. All layers on
Program remain as is.
~ The top Program bus is now mapped with the same inputs as the bottom
Preview bus, but only half of your inputs are available:
On the
Controller SC, inputs 1 - 6 and shifted inputs 7 - 12 are
available (but they are mapped to the Preview row). Inputs 13 -
24 are not available.
On the
Controller LC, inputs 1 - 16 and shifted inputs 17 - 32
are available (but they are mapped to the Preview row). Inputs
33 - 64 are not available.
4. With the mode enabled, there are several ways you can switch and transition:
~ Select a layer and a function (PIP or Key). On Preview, select (pend)
the desired source, then perform the desired transition. The source
transitions to
Program.
~ Select a layer and a function (PIP or Key) that is not already on
Program. Its "last selected" source appears on Preview. Select a
source directly on
Program to immediately cut that layer to Program.
~ Select a layer already on Program. Select a source on Preview or
Program to immediately cut that source into the layer.
~ Use the Clear Layer function in the normal way to transition layers off of
the
Program bus.
5. To clear the entire mode, press Shift + Program/Preview. The button turns off,
and the entire
Source Selection Bus is returned to its normal functionality.
Program
Preview