Barco 26-0313000-00 Projector User Manual


 
Encore Presentation System • User’s Guide • Rev 04 173
5. Menu Orientation
System Menu
póëíÉã=jÉåì=aÉëÅêáéíáçå
The figure below illustrates the System Menu:
Figure 5-23. System Menu (sample)
To access the menu:
Press {SYSTEM} on the Home Menu, or press System in the Keypad Section.
The
System Menu enables you to configure the Controller:
Modify Layers On Program — when enabled, you can change PIPs and Keys
directly on Program, without first setting up your “look” on Preview. When
disabled, you must use Preview to set up the next look. In Chapter 7, refer to the
Modifying Layers On Program” section on page 328 for details.
Tally Mode — enables or disables the tally function.
~ When enabled, all eight tallies are activated, and can be triggered by
pressing a source button.
~ When disabled, all tallies are deactivated (but tally setups remain as
configured).
In Chapter 6, refer to the “
Output Format Setup” section on page 285 for tally
setup details. In Chapter 7, refer to the “
Working with Tallies” section on
page 351 for tally operating instructions.
Press {RESET} to display the System Reset Menu. Refer to the “System Reset
Menu” section on page 175 for details.
Press {SW VER} to display the Software Version Menu. Refer to the “Software
Version Menu” section on page 176 for details.
Press {DIAG} to display the Diagnostics Setup Menu. Refer to the
Diagnostics Setup Menu” section on page 177 for details.
Press {DEST SETUP} to display the Destination Setup Menu. Refer to the
Destination Setup Menu” section on page 182 for details.
Press {NETWORK SETUP} to display the Network Setup Menu. Refer to the
Network Setup Menu” section on page 187 for details.
H
O
M
E
N
A
V
A
D
J
SYSTEM MENU
D
I
A
G
DEST
SETUP
ROUTER
SETUP
R
E
S
E
T
SW
V
E
R
NETWORK
SETUP
INPUT
PATCH
Modify Layers On Program Off
Tally Mode Off