Filter
Top Products
Encore Presentation System • User’s Guide • Rev 04 291
6. System Setup
Background Setup
_~ÅâÖêçìåÇ=pÉíìé
Encore system setup: Step 16
S Prerequisites — Ensure that you are familiar with the following menus:
~ Background Input Setup Menu. In Chapter 5, refer to the
“
Background Input Setup Menu” section on page 237.
~ BG Matte Menu. In Chapter 5, refer to the “BG Matte Menu” section on
page 241.
In this procedure, you will set up the Controller’s two “background” sources (for the
BG A
and
BG B buttons). An Encore background can be configured as a DVI input, an analog
input, a matte color or a frame grab.
Please note the following important points:
• For ScreenPRO-II destinations, remember that BG B and the DSK are mutually
exclusive. This occurs because the
BG/DSK Input B is shared between the DSK
and
BG B on all individual ScreenPRO-II units.
• For single or wide screen Encore systems using single M/E Video Processors,
there are only two DVI input connectors available (
1A and 1B). In this
configuration, you can not set up both backgrounds and the DSK — you can only
configure two of the three (e.g., both backgrounds, or one background plus DSK).
• For stack configurations, remember that the background sources connect to the
“bottom” stack Processor, while DSK sources connect to the “top” stack.
Use the following steps to set up your background sources:
1. On the Destination Bus, select the destination whose background sources you
want to configure.
2. On the Controller, press BG A to display the Background Input Setup Menu.
3. To configure a matte background:
a. Scroll to the Type line and select Matte.
b. Press {MATTE} to display the BG Matte Menu.
c. Adjust the matte color as desired.
d. Press {BACK} to return to the Background Input Setup Menu.
e. Press {SAVE}.
4. To configure a DVI background:
a. Ensure that your DVI source (e.g., a PC) is properly connected to the
Video Processor or ScreenPRO-II chassis, and that the PC is turned on.
b. Ensure that EDID is properly set. If not, refer to the “Programming
EDID” section on page 268 for details.
c. Scroll to the Type line and select DVI.
d. Set the DVI source’s format:
• Press
{FORCE ACQUIRE}, or ...
• To manually set the source’s resolution, select the desired
format on the
Format line, then press {APPLY FORMAT}.
e. (Optional) Adjust H Offset and V Offset as required.
16