Barco 26-0313000-00 Projector User Manual


 
Encore Presentation System • User’s Guide • Rev 04 275
6. System Setup
Input Patching
fåéìí=m~íÅÜáåÖ
Encore system setup: Step 9
S Prerequisites — Ensure that you are familiar with the Input Source Patch
Menu
. In Chapter 5, refer to the “Input Source Patch Menu” section on
page 188.
This procedure enables you to associate (patch) specific router inputs to specific source
buttons on the Controller, and also assign tally connections. This procedure is also used
for assigning “direct” connections (from PCs or video sources) to source buttons.
On the Controller SC, up to 24 inputs can be assigned.
On the Controller LC, up to 64 inputs can be assigned.
Encore creates a unique “
Input Patch Table for each default router. After a factory reset,
the Input Patch Table defaults to the following settings:
You may elect to use the default patches as shown above, or you can create custom
patches as required for specific input configurations.
9
Important
You may not need to change the input patches if you elect to
use those in the default
Input Patch Table.
Table 6-2. Default input patch table after factory reset
Router
Number
Router
Name
Router
Type
Router
Sources:
Map to
Encore Sources:
Encore
Tally
Controller LC
1 MatrixPRO1 Analog 1 - 16 1 - 16 1 - 8 defined only
2 MatrixPRO2 SDI 17 - 32 17 - 32 Undefined
3 MatrixPRO3 DVI 33 - 48 33 - 48 Undefined
Controller SC
1 MatrixPRO1 Analog 1 - 16 1 - 16 1 - 8 defined only
2 MatrixPRO2 SDI 17 - 24 17 - 24 Undefined
3 MatrixPRO3 DVI Undefined N/A Undefined
Tip
The same router input can be patched to one (or more)
source numbers. For example, if you want to use a DVD
player in both 16:9 and 4:3 formats, patch the DVD to inputs
10 and 42 (the shifted source 10). Using the input setup
procedure, set up each input for the desired aspect ratio.