Filter
Top Products
112 Encore Presentation System • User’s Guide • Rev 04
4. Controller Orientation
Controller SC Front Panel
4) Preset Section
The Preset Section enables you to store and recall Controller setups, called
“presets.” On the Controller SC, you have access to 64 presets — 8 pages of 8
presets each. Refer to the “
Preset Section” heading on page 123 for details.
5) Destination Bus
The Destination Bus allows you to route the Controller’s output to one or more
destinations. On the Controller SC, six destinations are available. Refer to the
“
Destination Bus” section on page 125 for details.
6) Group Control Section
The Group Control Section enables you to take one or more destinations and
assign them to a single button. On the Controller SC, four Group buttons are
available. See the “
Group Control Section” heading on page 137.
7) Source Selection Bus
The Source Selection Bus allows you to choose the sources that are routed into
PIPs and Keys. On the Controller SC, up to 24 sources can be mapped to
individual buttons. See the “
Source Selection Bus” section on page 126.
8) Layer Functions Section
When a layer is active in the Layer Control Section, all buttons in the Layer
Functions Section apply to that layer, enabling you to manipulate the source.
Refer to the “
Layer Functions Section” heading on page 131 for details.
9) Live Switch Section
The two buttons in the Live Switch section temporarily change the function of the
Source Selection Bus, enabling you to take sources “live” to Program. Refer to
the “
Live Switch Section” heading on page 134 for details.
10) Console Lighting
The Console Lighting Section enables you to control the two low-voltage “script”
lights. See the “
Console Lighting” section on page 122 for details.
11) Program Preset Section
The buttons in the Program Preset Section allow you to take a preset directly to
Program, without first viewing it on Preview. Refer to the “
Program Preset
Section” heading on page 139 for details.
12) Layer/Aux Control Section
The buttons in the Layer/Aux Control Section provide additional “on air” layer
control. Refer to the “
Layer/Aux Control Section” heading on page 140.
13) Transition Functions Section
The buttons in the Transition Functions Section enable you to manipulate the
current transition and mode. Refer to the “
Transition Functions Section”
heading on page 142 for details.
14) Transition Section
The Transition Section includes the T-Bar for manually mixing sources on and
off Program, plus dedicated buttons for cuts, automatic transitions and
sequencing. Refer to the “
Transition Section” heading on page 135 for details.
15) Layer Control Section
The Layer Control Section enables you to assign sources to PIPs and Keys on
each layer. On the Controller SC, six layers on three mixers can be controlled.
See the “
Layer Control Section” heading on page 128 for details.