Filter
Top Products
CTS 710 SONET Test Set User Manual
3–23
Setting Test Control Parameters
This section describes how to set the duration for a test, the
resolution of the test history, and how to start and stop a test. It also
lists parameters that cannot be adjusted during a test and other
actions that cannot be performed while a test is running.
Setting the Test Time Duration
Before running a test, you must specify how long the test will run.
The default test duration is continuous, which means a test runs until
you stop it with the START/STOP button.
To set the duration of a test:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
TEST SETUPS TEST CONTROL
(see Figure 3–8)
Test Duration 5 min
15 min
1 hour
Continuous
USER DEFINED
H Select Continuous to set the test to run until the START/STOP
button is pressed. If you select Continuous, the CTS 710
accumulates measurements from the time you start the test until
the time you stop the test.
CTS 710 SONET Test Set User Manual
3–23
Setting Test Control Parameters
This section describes how to set the duration for a test, the
resolution of the test history, and how to start and stop a test. It also
lists parameters that cannot be adjusted during a test and other
actions that cannot be performed while a test is running.
Setting the Test Time Duration
Before running a test, you must specify how long the test will run.
The default test duration is continuous, which means a test runs until
you stop it with the START/STOP button.
To set the duration of a test:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
TEST SETUPS TEST CONTROL
(see Figure 3–8)
Test Duration 5 min
15 min
1 hour
Continuous
USER DEFINED
H Select Continuous to set the test to run until the START/STOP
button is pressed. If you select Continuous, the CTS 710
accumulates measurements from the time you start the test until
the time you stop the test.