Filter
Top Products
Checking Signal Status
3–58
CTS 710 SONET Test Set User Manual
This shows that an alarm was
detected in the VT.
This means the VT is equipped. That is,
the signal label (in the V5 byte) is not zero,
indicating that the VT is probably carrying
traffic.
This means the transmitted test
pattern was found in the VT.
Figure 3–20: The Meaning of the Icons in the Autoscan Dialog Box
You exit the AUTOSCAN dialog box by selecting EXIT. When you
exit the AUTOSCAN dialog box, the receiver settings are set to
match the active channel most recently selected.
Printing the AutoScan Dialog Box
You can print the AutoScan dialog box by selecting Print. This
prints the displayed dialog box using the settings on the PRINTER
SETUP page of the UTILITY menu. The printout takes about two
minutes.
Viewing the Signal State
Three colors are used to indicate signal state: green, red, and yellow
(see Figure 3–21).
Checking Signal Status
3–58
CTS 710 SONET Test Set User Manual
This shows that an alarm was
detected in the VT.
This means the VT is equipped. That is,
the signal label (in the V5 byte) is not zero,
indicating that the VT is probably carrying
traffic.
This means the transmitted test
pattern was found in the VT.
Figure 3–20: The Meaning of the Icons in the Autoscan Dialog Box
You exit the AUTOSCAN dialog box by selecting EXIT. When you
exit the AUTOSCAN dialog box, the receiver settings are set to
match the active channel most recently selected.
Printing the AutoScan Dialog Box
You can print the AutoScan dialog box by selecting Print. This
prints the displayed dialog box using the settings on the PRINTER
SETUP page of the UTILITY menu. The printout takes about two
minutes.
Viewing the Signal State
Three colors are used to indicate signal state: green, red, and yellow
(see Figure 3–21).