Filter
Top Products
Setting Test Control Parameters
CTS 710 SONET Test Set User Manual
3–27
To set the history resolution of a test:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
TEST SETUPS TEST CONTROL
(see Figure 3–8
on page 3–24)
History
Resolution
Normal (1 min)
Low (15 min)
Starting and Stopping a Test
To start or stop a test:
H Press START/STOP.
When a test starts, the light next to the START/STOP button turns on
and the status line displays the message, Running.
NOTE. Pressing START/STOP while a test is running stops the test
immediately, even if the test time has not expired.
While a test is running, the status line shows the elapsed time since
the test began. If a limited test duration has been set (any setting
other than Continuous), a bar graph indicates the current percentage
of test completion. Figure 3–10 shows the locations of the elapsed
time indicator and bar graph.
Setting Test Control Parameters
CTS 710 SONET Test Set User Manual
3–27
To set the history resolution of a test:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
TEST SETUPS TEST CONTROL
(see Figure 3–8
on page 3–24)
History
Resolution
Normal (1 min)
Low (15 min)
Starting and Stopping a Test
To start or stop a test:
H Press START/STOP.
When a test starts, the light next to the START/STOP button turns on
and the status line displays the message, Running.
NOTE. Pressing START/STOP while a test is running stops the test
immediately, even if the test time has not expired.
While a test is running, the status line shows the elapsed time since
the test began. If a limited test duration has been set (any setting
other than Continuous), a bar graph indicates the current percentage
of test completion. Figure 3–10 shows the locations of the elapsed
time indicator and bar graph.