Filter
Top Products
CTS 710 SONET Test Set User Manual
B–1
Appendix B: Status and Error Messages
This appendix describes the status and error messages that appear on
the CTS 710 display. Status messages are statements about actions
the CTS 710 has completed. Status messages appear during normal
operation. Error messages are statements about actions the CTS 710
was unable to complete. Error messages appear when the CTS 710 is
unable to perform a requested action.
Status Messages
Autoscan complete. The CTS 710 has successfully completed the
Autoscan sequence.
Burst pointer movement transmitted. The POINTER ACTION button
was pressed with the Pointer Control set to Burst.
Disk root directory read. The CTS 710 has successfully read the disk
directory.
Factory settings restored, non-volatile settings cleared. This message
appears when the instrument is turned on after it was turned off
during a state change. The instrument settings were corrupted during
the shutdown and so the factory default settings were loaded at
turn-on and all information stored in RAM was cleared.
File has been deleted. The CTS 710 has successfully deleted the
selected file.
Hardcopy complete. The CTS 710 has successfully completed a
printout.
CTS 710 SONET Test Set User Manual
B–1
Appendix B: Status and Error Messages
This appendix describes the status and error messages that appear on
the CTS 710 display. Status messages are statements about actions
the CTS 710 has completed. Status messages appear during normal
operation. Error messages are statements about actions the CTS 710
was unable to complete. Error messages appear when the CTS 710 is
unable to perform a requested action.
Status Messages
Autoscan complete. The CTS 710 has successfully completed the
Autoscan sequence.
Burst pointer movement transmitted. The POINTER ACTION button
was pressed with the Pointer Control set to Burst.
Disk root directory read. The CTS 710 has successfully read the disk
directory.
Factory settings restored, non-volatile settings cleared. This message
appears when the instrument is turned on after it was turned off
during a state change. The instrument settings were corrupted during
the shutdown and so the factory default settings were loaded at
turn-on and all information stored in RAM was cleared.
File has been deleted. The CTS 710 has successfully deleted the
selected file.
Hardcopy complete. The CTS 710 has successfully completed a
printout.