Filter
Top Products
Appendix H: Changing Optical Port Connectors
H–2
CTS 710 SONET Test Set User Manual
NOTE. To keep cleaning to a minimum, install the dustcap when no
fiber is connected to the optical port.
Optical
Fiber
Connector
Figure H–1: Removing the Optical Bulkhead Connector
Changing the Optical Port Connectors
The CTS 710 is shipped with the FC connector bulkhead and dustcap
installed. If you wish to change to the ST, DIN 47256, or SC
connectors perform the following procedure:
1. Verify that the CTS 710 has been turned off with the principal
power switch on the rear panel.
2. Remove the four screws that attach the bulkhead connector to the
front panel (see Figure H–1).
3. Gently pull the bulkhead out of the unit and unscrew the fiber
connector. Be careful not to pull beyond the fiber slack.
4. Disassemble the bulkhead as shown in Figures H–2 through H–5.
Appendix H: Changing Optical Port Connectors
H–2
CTS 710 SONET Test Set User Manual
NOTE. To keep cleaning to a minimum, install the dustcap when no
fiber is connected to the optical port.
Optical
Fiber
Connector
Figure H–1: Removing the Optical Bulkhead Connector
Changing the Optical Port Connectors
The CTS 710 is shipped with the FC connector bulkhead and dustcap
installed. If you wish to change to the ST, DIN 47256, or SC
connectors perform the following procedure:
1. Verify that the CTS 710 has been turned off with the principal
power switch on the rear panel.
2. Remove the four screws that attach the bulkhead connector to the
front panel (see Figure H–1).
3. Gently pull the bulkhead out of the unit and unscrew the fiber
connector. Be careful not to pull beyond the fiber slack.
4. Disassemble the bulkhead as shown in Figures H–2 through H–5.