Filter
Top Products
Appendix B: Status and Error Messages
CTS 710 SONET Test Set User Manual
B–5
Disk is full. You tried to save a file to disk and there is not enough
room on the disk for the file. Insert a disk with space available and
save the file again.
Disk not present in drive. You tried to save a file to disk, but no disk is
in the drive. Insert a formatted disk and save the file again.
Disk is write-protected, cannot write to file. You tried to save a file to a
disk that is write-protected.
Disk operation failed. A disk error occurred while reading or writing
to the disk. If you were trying to save a file to disk, save the file to a
different disk. If you were trying to read a file from disk, you might
be able to recover the file using an MS-DOS disk recovery program.
Error insertion disabled while in Through Mode. You pressed the
INSERT ERROR button while the CTS 710 was in Through Mode.
You cannot insert errors while the CTS 710 is in Through Mode
because the transmit signal must match the received signal.
Errors in test recall, test not loaded. The CTS 710 encountered disk
errors while recalling a pass/fail test and the operation was aborted.
You might be able to recover the file with an MS-DOS disk recovery
program.
Extra data in history file ignored. You recalled a history file that
contains extra data. This can occur if the history file has been edited
with a file editor and the edited file contains inappropriate informa-
tion.
Failure generation invalid while in through mode. You attempted to
transmit a failure while the CTS 710 was in Through Mode. Transmit
settings cannot be changed while the transmit rate is set to Through
Mode.
File name required. You entered a name for an instrument setup, a
pass/fail test, or a results file and then you removed the name by
selecting Clear. This message is just a reminder that a name must be
Appendix B: Status and Error Messages
CTS 710 SONET Test Set User Manual
B–5
Disk is full. You tried to save a file to disk and there is not enough
room on the disk for the file. Insert a disk with space available and
save the file again.
Disk not present in drive. You tried to save a file to disk, but no disk is
in the drive. Insert a formatted disk and save the file again.
Disk is write-protected, cannot write to file. You tried to save a file to a
disk that is write-protected.
Disk operation failed. A disk error occurred while reading or writing
to the disk. If you were trying to save a file to disk, save the file to a
different disk. If you were trying to read a file from disk, you might
be able to recover the file using an MS-DOS disk recovery program.
Error insertion disabled while in Through Mode. You pressed the
INSERT ERROR button while the CTS 710 was in Through Mode.
You cannot insert errors while the CTS 710 is in Through Mode
because the transmit signal must match the received signal.
Errors in test recall, test not loaded. The CTS 710 encountered disk
errors while recalling a pass/fail test and the operation was aborted.
You might be able to recover the file with an MS-DOS disk recovery
program.
Extra data in history file ignored. You recalled a history file that
contains extra data. This can occur if the history file has been edited
with a file editor and the edited file contains inappropriate informa-
tion.
Failure generation invalid while in through mode. You attempted to
transmit a failure while the CTS 710 was in Through Mode. Transmit
settings cannot be changed while the transmit rate is set to Through
Mode.
File name required. You entered a name for an instrument setup, a
pass/fail test, or a results file and then you removed the name by
selecting Clear. This message is just a reminder that a name must be