Filter
Top Products
Working with Test Setups
CTS 710 SONET Test Set User Manual
3–51
Figure 3–16: The TEST BEGIN Dialog Box
3. To run the pass/fail test immediately, press START/STOP.
The pass/fail test will begin. When the test is completed, the
CTS 710 displays either TEST PASSED! or TEST FAILED!.
If you decide not to run the test, select EXIT from the dialog
box.
4. Select EXIT to remove the dialog box after the test completes.
5. Press RESULTS to see the detailed results of the test.
A test does not have to be run when it is recalled from disk. After the
TEST BEGIN dialog box appears, you can exit the dialog box by
selecting EXIT. You can then select the SAVE PASS/FAIL TESTS
page and edit the parameters of the pass/fail test.
Changing an Existing Pass/Fail Test
You do not have to create a pass/fail test from the beginning every
time. You can recall an existing test, edit the parameters of the test,
and then save it under a new name.
Working with Test Setups
CTS 710 SONET Test Set User Manual
3–51
Figure 3–16: The TEST BEGIN Dialog Box
3. To run the pass/fail test immediately, press START/STOP.
The pass/fail test will begin. When the test is completed, the
CTS 710 displays either TEST PASSED! or TEST FAILED!.
If you decide not to run the test, select EXIT from the dialog
box.
4. Select EXIT to remove the dialog box after the test completes.
5. Press RESULTS to see the detailed results of the test.
A test does not have to be run when it is recalled from disk. After the
TEST BEGIN dialog box appears, you can exit the dialog box by
selecting EXIT. You can then select the SAVE PASS/FAIL TESTS
page and edit the parameters of the pass/fail test.
Changing an Existing Pass/Fail Test
You do not have to create a pass/fail test from the beginning every
time. You can recall an existing test, edit the parameters of the test,
and then save it under a new name.