Filter
Top Products
Setting Pointers and Changing Timing
CTS 710 SONET Test Set User Manual
3–159
7. Specify whether Cool Down Time is included as part of the
pointer sequence as follows:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
Cool Down Time On
Off
NOTE. The Cool Down Time is a calculated value based on the
sequence type; it cannot be changed directly.
8. To initiate a pointer sequence, press POINTER ACTION.
Pointer sequences will continue to run until they are stopped.
9. To stop a pointer sequence, press POINTER ACTION.
After you press POINTER ACTION, the pointer sequence begins.
The status area at the bottom of the display will change to
indicate where the CTS 710 is within the pointer sequence; see
Figure 3–54. Table 3–15 describes the meaning of the lines in the
status display.
Setting Pointers and Changing Timing
CTS 710 SONET Test Set User Manual
3–159
7. Specify whether Cool Down Time is included as part of the
pointer sequence as follows:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
Cool Down Time On
Off
NOTE. The Cool Down Time is a calculated value based on the
sequence type; it cannot be changed directly.
8. To initiate a pointer sequence, press POINTER ACTION.
Pointer sequences will continue to run until they are stopped.
9. To stop a pointer sequence, press POINTER ACTION.
After you press POINTER ACTION, the pointer sequence begins.
The status area at the bottom of the display will change to
indicate where the CTS 710 is within the pointer sequence; see
Figure 3–54. Table 3–15 describes the meaning of the lines in the
status display.