Filter
Top Products
Getting Started
CTS 710 SONET Test Set User Manual
1–3
H CTS 710 SONET Test Set & CTS 750 SDH Test Set Service
Manual (Tektronix part number 070-8853-XX)
H Hard Transit Case, Tektronix part number 016-1157-XX
H Soft Carrying Bag, Tektronix part number 016-1158-XX
H K212 Portable Instrument Cart
H Optical Connector Kit, Tektronix part number 020-1885-XX
First Time Operation
This section describes how to set up the CTS 710 for the first time.
Installing the Accessory Pouch
The CTS 710 ships with an accessory pouch that mounts on top of
the instrument. The pouch is not installed at the factory. To install
the accessory pouch:
1. Place the CTS 710 on a table or work bench with the front facing
toward you.
2. Center the pouch plate and insert the rear edge of the plate in the
space between the cabinet top and the rear panel trim (see part A
of Figure 1–1).
3. Move the pouch sideways as necessary to line up the key slots in
the pouch plate with the keys on the rear panel (the plate is
centered when it is aligned) and push the plate all the way in (see
part B of Figure 1–1).
4. While keeping the pouch plate pushed under the rear panel trim,
reach under the pouch plate and carefully remove the backing
from the Velcro strip to expose the adhesive on the Velcro strip.
The Velcro should remain attached to the pouch plate.
5. Grasp the pouch plate assembly with both hands near the front of
the assembly.
Getting Started
CTS 710 SONET Test Set User Manual
1–3
H CTS 710 SONET Test Set & CTS 750 SDH Test Set Service
Manual (Tektronix part number 070-8853-XX)
H Hard Transit Case, Tektronix part number 016-1157-XX
H Soft Carrying Bag, Tektronix part number 016-1158-XX
H K212 Portable Instrument Cart
H Optical Connector Kit, Tektronix part number 020-1885-XX
First Time Operation
This section describes how to set up the CTS 710 for the first time.
Installing the Accessory Pouch
The CTS 710 ships with an accessory pouch that mounts on top of
the instrument. The pouch is not installed at the factory. To install
the accessory pouch:
1. Place the CTS 710 on a table or work bench with the front facing
toward you.
2. Center the pouch plate and insert the rear edge of the plate in the
space between the cabinet top and the rear panel trim (see part A
of Figure 1–1).
3. Move the pouch sideways as necessary to line up the key slots in
the pouch plate with the keys on the rear panel (the plate is
centered when it is aligned) and push the plate all the way in (see
part B of Figure 1–1).
4. While keeping the pouch plate pushed under the rear panel trim,
reach under the pouch plate and carefully remove the backing
from the Velcro strip to expose the adhesive on the Velcro strip.
The Velcro should remain attached to the pouch plate.
5. Grasp the pouch plate assembly with both hands near the front of
the assembly.