Filter
Top Products
Basic Test Procedures
CTS 710 SONET Test Set User Manual
3–5
2. Set up the CTS 710 as follows:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
TEST SETUPS RECALL
INSTRUMENT
SETUPS
DEFAULT
FACTORY
SETTINGS
Recall Setup
TRANSMIT TRANSMIT
SETTINGS
Transmit Rate STS-1
Mapping Bulk Fill
No Mapping
(Equipped)
Tx/Rx Settings Coupled
TEST SETUPS TEST CONTROL Test Duration 15 Minutes
RESULTS MAIN RESULTS none Errors
3. Press the START/STOP button.
4. While the test is running, the CTS 710 counts errors and errored
seconds and then calculates the error ratio for each error type.
5. After 15 minutes have elapsed, the test stops automatically and
the measured results are held on the MAIN RESULTS page until
another test is started.
6. When the test is complete, you can store the test results to disk or
print out a hardcopy. To save the test results to disk, you must
enter a name for the disk file as follows:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
RESULTS SAVE RESULTS Name EDIT NAME
7. Enter an eight-character name for the file.
Basic Test Procedures
CTS 710 SONET Test Set User Manual
3–5
2. Set up the CTS 710 as follows:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
TEST SETUPS RECALL
INSTRUMENT
SETUPS
DEFAULT
FACTORY
SETTINGS
Recall Setup
TRANSMIT TRANSMIT
SETTINGS
Transmit Rate STS-1
Mapping Bulk Fill
No Mapping
(Equipped)
Tx/Rx Settings Coupled
TEST SETUPS TEST CONTROL Test Duration 15 Minutes
RESULTS MAIN RESULTS none Errors
3. Press the START/STOP button.
4. While the test is running, the CTS 710 counts errors and errored
seconds and then calculates the error ratio for each error type.
5. After 15 minutes have elapsed, the test stops automatically and
the measured results are held on the MAIN RESULTS page until
another test is started.
6. When the test is complete, you can store the test results to disk or
print out a hardcopy. To save the test results to disk, you must
enter a name for the disk file as follows:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
RESULTS SAVE RESULTS Name EDIT NAME
7. Enter an eight-character name for the file.