Filter
Top Products
Appendix B: Status and Error Messages
B–2
CTS 710 SONET Test Set User Manual
Instrument factory reset complete. The recall of default factory
settings, from the RECALL INSTRUMENT SETUPS page, was
completed successfully.
Instrument returned to previous setup. This message appears if you
select Cancel while an Autoscan is in progress.
Instrument setup for received signal. The CTS 710 has completed an
Autoscan and has changed its settings to match those of the received
signal.
Internal diagnostics completed. An instrument self test has been
initiated and completed successfully.
No Setup file with ’.SET’ extension found. You selected the Disk action
on the RECALL INSTRUMENT SETUPS page and no instrument
setup files were found on the disk.
Previous power down instrument state restored. This message appears
when the CTS 710 turns on. It means that the settings in effect when
the CTS 710 was last turned off have been successfully restored.
Reading disk.... The CTS 710 is reading the disk directory.
Recall of instrument setup complete. This message confirms that the
recall of an instrument setup was successfully completed.
Recall of measurement results/histories complete. The CTS 710 has
successfully recalled the selected results from disk.
Recall of pass/fail test complete. The CTS 710 has successfully
recalled the selected pass/fail test from disk.
Save of instrument setup complete. This message confirms that an
instrument setup was successfully written to disk.
Appendix B: Status and Error Messages
B–2
CTS 710 SONET Test Set User Manual
Instrument factory reset complete. The recall of default factory
settings, from the RECALL INSTRUMENT SETUPS page, was
completed successfully.
Instrument returned to previous setup. This message appears if you
select Cancel while an Autoscan is in progress.
Instrument setup for received signal. The CTS 710 has completed an
Autoscan and has changed its settings to match those of the received
signal.
Internal diagnostics completed. An instrument self test has been
initiated and completed successfully.
No Setup file with ’.SET’ extension found. You selected the Disk action
on the RECALL INSTRUMENT SETUPS page and no instrument
setup files were found on the disk.
Previous power down instrument state restored. This message appears
when the CTS 710 turns on. It means that the settings in effect when
the CTS 710 was last turned off have been successfully restored.
Reading disk.... The CTS 710 is reading the disk directory.
Recall of instrument setup complete. This message confirms that the
recall of an instrument setup was successfully completed.
Recall of measurement results/histories complete. The CTS 710 has
successfully recalled the selected results from disk.
Recall of pass/fail test complete. The CTS 710 has successfully
recalled the selected pass/fail test from disk.
Save of instrument setup complete. This message confirms that an
instrument setup was successfully written to disk.