Filter
Top Products
Tutorial
2–42
CTS 710 SONET Test Set User Manual
To edit a byte of the transport overhead:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
S1 byte
EDIT BYTE
Once you have selected EDIT BYTE, the CTS 710 enters the edit
mode (see Figure 2–30).
Figure 2–30: The Display in Edit Mode
To change the value of any bit within the byte, highlight the bit you
wish to change. To change the value of the highlighted bit, select
either 1 or 0. After you assign a value to the highlighted bit, the
highlight moves to the next bit to be edited.
Edit the S1 byte to read 10101010.
Select DONE when you have finished editing the byte.
You can assign preset values to the highlighted byte. For example,
rather than editing each bit of the byte as you just did, you could also
Tutorial
2–42
CTS 710 SONET Test Set User Manual
To edit a byte of the transport overhead:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
S1 byte
EDIT BYTE
Once you have selected EDIT BYTE, the CTS 710 enters the edit
mode (see Figure 2–30).
Figure 2–30: The Display in Edit Mode
To change the value of any bit within the byte, highlight the bit you
wish to change. To change the value of the highlighted bit, select
either 1 or 0. After you assign a value to the highlighted bit, the
highlight moves to the next bit to be edited.
Edit the S1 byte to read 10101010.
Select DONE when you have finished editing the byte.
You can assign preset values to the highlighted byte. For example,
rather than editing each bit of the byte as you just did, you could also