Filter
Top Products
Setting TributaryPDH Receive Parameters
CTS 710 SONET Test Set User Manual
3–127
Demultiplexing a DS1 from a DS3 Signal
To demultiplex a DS1 signal from a DS3 signal:
1. After setting the Receive Rate to DS3–>DS1 Demux, specify the
DS3 framing as follows:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
RECEIVE RECEIVE
SETTINGS
DS3 Framing DS3 C–bit
DS3 M13
2. Specify the DS1 User Test as follows:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
DS1 Under Test DS1 #1
DS1 #28
Next
Previous
H Select DS1 #1 to specify the first DS1 signal.
H Select DS1 #28 to specify the last DS1 signal.
H Select Next to change the selection to the next higher DS1
signal.
H Select Previous to change the selection to the next lower DS1
signal.
Setting TributaryPDH Receive Parameters
CTS 710 SONET Test Set User Manual
3–127
Demultiplexing a DS1 from a DS3 Signal
To demultiplex a DS1 signal from a DS3 signal:
1. After setting the Receive Rate to DS3–>DS1 Demux, specify the
DS3 framing as follows:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
RECEIVE RECEIVE
SETTINGS
DS3 Framing DS3 C–bit
DS3 M13
2. Specify the DS1 User Test as follows:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
DS1 Under Test DS1 #1
DS1 #28
Next
Previous
H Select DS1 #1 to specify the first DS1 signal.
H Select DS1 #28 to specify the last DS1 signal.
H Select Next to change the selection to the next higher DS1
signal.
H Select Previous to change the selection to the next lower DS1
signal.