Filter
Top Products
Viewing Results
3–192
CTS 710 SONET Test Set User Manual
Saving and Recalling Results
You can save test results to disk and recall the test results for later
display and analysis. The CTS 710 automatically saves the results of
the last two tests in memory. If you want to save test results
permanently, you must save the test results to disk.
Saving Test Results to Disk
NOTE. The CTS 710 saves only the last 3 days (at a History
Resolution of Normal) or 45 days (at a History Resolution of Low) of
test results. If a test runs longer than these limits, the results older
than 3 days/45 days are discarded.
To save test results to disk:
1. Name the test results file as follows:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
RESULTS SAVE RESULTS
(see Figure 3–63)
Name RESLT_XX
Clear
EDIT NAME
H If you wish to name the results file as RESLT<Number>, you
can save time by selecting RESLT_XX. Once you select
RESLT_XX, select EDIT NAME and edit XX to the desired
number (or letter). Select DONE when you are finished
editing the setup name.
H Select Clear to remove an existing name. A message appears
to remind you that you cannot save results to disk without a
name.
Viewing Results
3–192
CTS 710 SONET Test Set User Manual
Saving and Recalling Results
You can save test results to disk and recall the test results for later
display and analysis. The CTS 710 automatically saves the results of
the last two tests in memory. If you want to save test results
permanently, you must save the test results to disk.
Saving Test Results to Disk
NOTE. The CTS 710 saves only the last 3 days (at a History
Resolution of Normal) or 45 days (at a History Resolution of Low) of
test results. If a test runs longer than these limits, the results older
than 3 days/45 days are discarded.
To save test results to disk:
1. Name the test results file as follows:
Press Menu
Button
Select Menu
Page
Highlight
Parameter
Select Choice
RESULTS SAVE RESULTS
(see Figure 3–63)
Name RESLT_XX
Clear
EDIT NAME
H If you wish to name the results file as RESLT<Number>, you
can save time by selecting RESLT_XX. Once you select
RESLT_XX, select EDIT NAME and edit XX to the desired
number (or letter). Select DONE when you are finished
editing the setup name.
H Select Clear to remove an existing name. A message appears
to remind you that you cannot save results to disk without a
name.