Filter
Top Products
D-Link DWS-1008 CLI Manual 107
DWS-1008# set snmp notify profile snmpprof_rfdetect send
RFDetectSpoofedSsidAPTraps
success: change accepted.
DWS-1008# set snmp notify profile snmpprof_rfdetect send
RFDetectUnAuthorizedAPTraps
success: change accepted.
DWS-1008# set snmp notify profile snmpprof_rfdetect send
RFDetectUnAuthorizedOuiTraps
success: change accepted.
DWS-1008# set snmp notify profile snmpprof_rfdetect send
RFDetectUnAuthorizedSsidTraps
success: change accepted.
set snmp notify target
Configures a notification target for notifications from SNMP.
A notification target is a remote device to which MSS sends SNMP notifications. You can configure
the MSS SNMP engine to send confirmed notifications (informs) or unconfirmed notifications
(traps). Some of the command options differ depending on the SNMP version and the type of
notification you specify. You can configure up to 10 notification targets.
SNMPv3 with Informs
To configure a notification target for informs from SNMPv3, use the following command:
Syntax: set snmp notify target target-num ip-addr [:udp-port-number]
usm inform user username snmp-engine-id {ip | hex hex-string}
[profile profile-name] [security {unsecured | authenticated | encrypted}]
[retries num] [timeout num]
target-num ID for the target. This ID is local to the switch and does not need to
correspond to a value on the target itself. You can specify a number
from 1 to 10.
ip-addr[:udp-port-number] IP address of the server. You also can specify the UDP port number
to send notifications to.
username USM username. This option is applicable only when the SNMP
version is usm. If the user will send informs rather than traps,
you also must specify the snmp-engine-id of the target.