Filter
Top Products
D-Link DWS-1008 CLI Manual 317
Examples: The following command enables LED blink mode on the access points connected
to ports 3 and 4:
DWS-1008# set ap 3-4 blink enable
success: change accepted.
set dap boot-ip
Specifies static IP address information for a Distributed AP.
Syntax: set dap dap-num boot-ip ip ip-addr netmask mask-addr gateway
gateway-addr [mode {enable | disable}]
Syntax: set dap dap-num boot-ip mode {enable | disable}
dap dap-num
ip ip-addr
netmask mask-addr
gateway gateway-addr
mode {enable | disable}
Defaults: By default APs use DHCP to obtain an IP address, rather than a using a manually
assigned IP address.
Access: Enabled
Usage: Normally, Distributed APs use DHCP to obtain IP address information. In some installations,
DHCP may not be available. In this case, you can assign static IP address information to the AP,
including the AP’s IP address and netmask, and default gateway.
If the manually assigned IP information is incorrect, the AP uses DHCP to obtain its IP address.
Number of the Distributed AP for which you are specifying static IP
information.
The IP address to be assigned to the AP, in dotted decimal notation
(for example, 10.10.10.10).
The subnet mask, in dotted decimal notation (for example,
255.255.255.0).
The IP address of the next-hop router, in dotted decimal notation.
Enables or disables the static IP address for the AP.