Filter
Top Products
D-Link DWS-1008 CLI Manual 370
name
enable
disable
Defaults: This option is disabled by default.
Access: Enabled.
Usage: Even when this option is enabled, the DWS-1008 to which a user roams (the roamed-to
switch) can reassign the VLAN in any of the following cases:
Examples: The following command enables the keep-initial-vlan option on service profile sp3:
DWS-1008# set service-profile sp3 keep-initial-vlan enable
success: change accepted.
See Also:
• show service-profile
Service profile name.
Enables radios to leave a roamed user on the same VLAN instead of reassigning
the VLAN.
Configures radios to reassign a roamed user’s VLAN.
• A location policy on the local switch reassigns the VLAN.
• The user is configured in the switch’s local database and the VLAN-Name attribute
is set on the user or on a user group the user is in.
• The access rule on the roamed-to switch uses RADIUS, and the VLAN-Name
attribute is set on the RADIUS server.
set service-profile long-retry-count
Changes the long retry threshold for a service profile. The long retry threshold specifies the
number of times a radio can send a long unicast frame without receiving an acknowledgment. A
long unicast frame is a frame that is equal to or longer than the frag-threshold.
Syntax: set service-profile name long-retry-count threshold
name
threshold
Defaults: The default long unicast retry threshold is 5 attempts.
Service profile name.
Number of times the radio can send the same long unicast frame. You can enter
a value from 1 through 15.