Filter
Top Products
D-Link DWS-1008 CLI Manual 152
zone-name Time zone name of up to 32 alphabetic characters. You can use a
standard name or any name you like.
- Minus time to indicate hours (and minutes) to be subtracted from UTC.
Otherwise, hours and minutes are added by default.
hours Number of hours to add or subtract from UTC.
minutes Number of minutes to add or subtract from UTC.
Defaults: If this command is not used, then the default time zone is UTC.
Access: Enabled.
Examples: To set the time zone for Pacific Standard Time (PST), type the following command:
DWS-1008# set timezone PST -8
Timezone is set to ‘PST’, offset from UTC is -8:0 hours.
See Also:
• clear summertime
• clear timezone
• set summertime
• set timedate
• show summertime
• show timedate
• show timezone
show arp
Displays the ARP table.
Syntax: show arp [ip-addr]
ip-addr IP address.
Defaults: If you do not specify an IP address, the whole ARP table is displayed.
Access: All.
Examples: The following command displays ARP entries:
DWS-1008# show arp
ARP aging time: 1200 seconds
Host HW Address VLAN Type State
---------------------------------------------------------------------------------------
10.5.4.51 00:0b:0e:02:76:f5 1 DYNAMIC RESOLVED
10.5.4.53 00:0b:0e:02:76:f7 1 LOCAL RESOLVED