Filter
Top Products
D-Link DWS-1008 CLI Manual 311
Examples: The following commands disable the radios that are using radio profile rp6, remove
service-profile svcprof6 from rp6, then clear svcprof6 from the configuration.
DWS-1008# set radio-profile rp6 mode disable
DWS-1008# clear radio-profile rp6 service-profile svcprof6
success: change accepted.
DWS-1008# clear service-profile svcprof6
success: change accepted.
See Also:
• clear radio-profile
• set radio-profile mode
• show service-profile
reset {ap | dap}
Restarts an access point.
Syntax: reset {ap port-list | dap dap-num}
ap port-list
dap dap-num
Defaults: None.
Access: Enabled
Usage: When you enter this command, the AP drops all sessions and reboots.
Examples: The following command resets the AP on port 4:
DWS-1008# reset ap 4
This will reset specified AP devices. Would you like to continue? (y/n)y
success: rebooting ap attached to port 4
List of ports connected to the access points to restart.
Number of a Distributed AP to reset.