Filter
Top Products
D-Link DWS-1008 CLI Manual 465
The table below describes the fields in the display when a querier other than the switch is present.
Field Description
Querier for vlan VLAN containing the querier. Information is listed separately for each VLAN.
Querier-IP IP address of the querier interface.
Querier-MAC MAC address of the querier interface.
TTL
Number of seconds before this entry ages out if the switch does not receive a query message
from the querier.
See Also:
• set igmp querier
show igmp receiver-table
Displays the receivers to which a switch forwards multicast traffic. You can display receivers for all
VLANs, a single VLAN, or a group or groups identified by group address and network mask.
Syntax: show igmp receiver-table [vlan vlan-id] [group group-ip-addr/mask-length]
vlan vlan-id VLAN name or number. If you do not specify a VLAN, MSS
displays the multicast receivers on all VLANs.
group group-ip-addr/mask-length IP address and subnet mask of a multicast group, in CIDR
format (for example, 239.20.20.10/24). If you do not specify
a group address, MSS displays the multicast receivers for all
groups.
Defaults: None.
Access: All.
Examples: The following command displays all multicast receivers in VLAN orange:
DWS-1008# show igmp receiver-table vlan orange
VLAN: orange
Session Port Receiver-IP Receiver-MAC TTL
----------------------------------------------------------------------------------------
224.0.0.2 none none none undef
237.255.255.255 5 10.10.10.11 00:02:04:06:08:0b 179
237.255.255.255 5 10.10.10.13 00:02:04:06:08:0d 179
237.255.255.255 5 10.10.10.14 00:02:04:06:08:0e 179
237.255.255.255 5 10.10.10.12 00:02:04:06:08:0c 179
237.255.255.255 5 10.10.10.10 00:02:04:06:08:0a 179