Filter
Top Products
D-Link DWS-1008 CLI Manual 347
Parameter Default Value Radio Behavior When Parameter Set to Default Value
active-scan enable
Sends probe any requests (probe requests with a
null SSID name) to solicit probe responses from
other access points.
auto-tune enable
Allows dynamic configuration of channel and power settings by
MMS.
beacon-interval 100 Waits 100ms between beacons.
countermeasures Not configured Does not issue countermeasures against any device.
dtim-interval 1
Sends the delivery traffic indication map (DTIM) after every
beacon.
frag-threshold 2346
Uses the short-retry-count for frames shorter than 2346 bytes
and uses the long-retry-count for frames that are 2346 bytes or
longer.
max-rx-lifetime 2000
Allows a received frame to stay in the buffer for up to 2000ms (2
seconds).
max-tx-lifetime 2000
Allows a frame that is scheduled for transmission to stay in the
buffer for up to 2000ms (2 seconds).
preamble-length short
Advertises support for short 802.11b preambles, and generates
unicast frames with the preamble length specified by the client.
Note: This parameter applies only to 802.11b/g radios.
qos-mode wmm
Classifies and marks traffic based on 802.1q and DSCP,
and optimizes forwarding prioritization of AP radios for Wi-Fi
Multimedia (WMM).
rfid-mode disable
Radio does not funtion as a location reciever in an AreoScout
Visibility System.
rts-threshold 2346
Transmits frames longer than 2346 bytes by means of the
Request-to-Send/Clear-to-Send (RTS/CTS) method.
service-profile No service profiles defined
You must configure a service profile. The service profile sets the
SSID name and other parameters.
wmm-powersave disable
Requires clients to send a seperate PSpoll to retrieve each
unicast packet buffered by the AP.
The table below lists the parameters controlled by a radio profile and their default values.