Filter
Top Products
D-Link DWS-1008 CLI Manual 344
set radio-profile frag-threshold
Changes the fragmentation threshold for the DWL-8220AP radios in a radio profile. The
fragmentation threshold is the threshold at which the long-retry-count is applicable instead of the
short-retry-count.
The long-retry-count specifies the number of times a radio can send a unicast frame that is equal
to or longer than the frag-threshold without receiving an acknowledgment.
The short-retry-count specifies the number of times a radio can send a unicast frame that is
shorter than the frag-threshold without receiving an acknowledgment.
Syntax: set radio-profile name frag-threshold threshold
name
threshold
Defaults: The default fragmentation threshold for DWL-8220AP radios is 2346 bytes.
Access: Enabled.
Usage: You must disable all radios that are using a radio profile before you can change parameters
in the profile. Use the set radio-profile mode command.
The frag-threshold does not specify the maximum length a frame is allowed to be
without being broken into multiple frames before transmission.
The frag-threshold does not change the RTS threshold, which specifies the maximum length a
frame can be before the radio uses the RTS/CTS method to send the frame. To change the RTS
threshold, use the set radio-profile rts-threshold command instead.
Examples: The following command changes the fragmentation threshold for radio profile rp1 to
1500 bytes:
DWS-1008# set radio-profile rp1 frag-threshold 1500
success: change accepted.
See Also:
• set radio-profile mode
• set radio-profile rts-threshold
• set service-profile long-retry-count
• set service-profile short-retry-count
• show radio-profile
Radio profile name.
Maximum frame length, in bytes. You can enter a value from 256 through 2346.