Filter
Top Products
D-Link DWS-1008 CLI Manual 331
Defaults: When you create a new profile, the radio parameters in the profile are set to their
factory default values. To enable or disable all radios that use a specific radio profile, use set
radio-profile.
Access: Enabled.
Examples: The following command enables radio 1 on ports 4 through 6 assigned to radio
profile rp1:
DWS-1008# set ap 4-6 radio 1 radio-profile rp1 mode enable
success: change accepted.
set {ap | dap} radio tx-power
Sets an DWL-8220AP radio’s transmit power.
Syntax: set {ap port-list | dap dap-num} radio {1 | 2} tx-power power-level
ap port-list
dap dap-num
radio 1
radio 2
tx power
Defaults: The default transmit power on all DWL-8220AP radio types is the highest setting allowed
for the country of operation or highest setting supported on the hardware, whichever is lower.
Usage: To enable or disable one or more radios to which a profile is assigned, use the set ap
radio radio-profile command. To enable or disable all radios that use a specific radio profile, use
the set radio-profile command.
List of ports connected to the DWL-8220AP access points on which to set
the transmit power.
Number of a Distributed AP on which to set the transmit power.
Radio 1 of the DWL-8220AP.
Radio 2 of the DWL-8220AP.
Number of decibels in relation to 1 milliwatt (dBm). The power-level valid
values depend on the country of operation.
Note: The maximum transmit power you can configure on any D-Link radio
is the maximum allowed for the country in which you plan to operate the
radio or one of the following values if that value is less than the country
maximum: on an 802.11a radio, 11 dBm for channel numbers less than
or equal to 64, or 10 dBm for channel numbers greater than 64; on an
802.11b/g radio, 16 dBm for all valid channel numbers for 802.11b, or 14
dBm for all valid channel numbers for 802.11g.