Filter
Top Products
D-Link DWS-1008 CLI Manual 428
STP Commands
Use Spanning Tree Protocol (STP) commands to configure and manage spanning trees on the virtual
LANs (VLANs) configured on a switch, to maintain a loop-free network. This chapter presents STP
commands alphabetically. Use the following table to locate commands in this chapter based on their
use.
STP State set spantree on page 492
show spantree on page 502
show spantree blockedports on page 506
Bridge Priority set spantree priority on page 501
Port Cost set spantree portcost on page 496
set spantree portvlancost on page 499
show spantree portvlancost on page 508
clear spantree portcost on page 488
clear spantree portvlancost on page 490
Port Priority set spantree portpri on page 498
set spantree portvlanpri on page 500
clear spantree portpri on page 489
clear spantree portvlanpri on page 491
Timers set spantree fwddelay on page 494
set spantree hello on page 495
set spantree maxage on page 495
Fast Convergence set spantree portfast on page 498
show spantree portfast on page 507
set spantree backbonefast on page 493
show spantree backbonefast on page 506
set spantree uplinkfast on page 502
show spantree uplinkfast on page 516
Statistics show spantree statistics on page 509
clear spantree statistics on page 492