Filter
Top Products
D-Link DWS-1008 CLI Manual 466
The following command lists all receivers for multicast groups 237.255.255.1 through
237.255.255.255, in all VLANs:
DWS-1008# show igmp receiver-table group 237.255.255.0/24
VLAN: red
Session Port Receiver-IP Receiver-MAC TTL
---------------------------------------------------------------------------------------
237.255.255.2 2 10.10.20.19 00:02:04:06:09:0d 112
237.255.255.119 3 10.10.30.31 00:02:04:06:01:0b 112
VLAN: green
Session Port Receiver-IP Receiver-MAC TTL
---------------------------------------------------------------------------------------
237.255.255.17 11 10.10.40.41 00:02:06:08:02:0c 12
237.255.255.255 6 10.10.60.61 00:05:09:0c:0a:01 111
The table below describes the fields in this display.
Field Description
VLAN VLAN that contains the multicast receiver ports. Ports are listed separately for each VLAN.
Session IP address of the multicast group being received.
Port Physical port through which the switch can reach the receiver.
Receiver-IP IP address of the receiver.
Receiver-MAC MAC address of the receiver.
TTL
Number of seconds before this entry ages out if the switch does not receive a group membership
message from the receiver. For static multicast receiver entries, the TTL value is undef. Static
multicast receiver entries do not age out.
See Also:
• set igmp receiver
show igmp statistics
Displays IGMP statistics.
Syntax: show igmp statistics [vlan vlan-id]
vlan vlan-id VLAN name or number. If you do not specify a VLAN, MSS displays IGMP
statistics for all VLANs.
Defaults: None.
Access: All.